Single acting piston pump with simple structure, nominal flow rate of 160L/min at 1000r/min, nominal flow rate of 240L/min at 1000r/min, inlet and outlet diameter and connection and system matching, easy installation and disassembly.
Specification
Model: ATO-PP-160YCY
Max Drive Power: 125 hp (94.5 kW)
Driving Method: Hydraulic
Theoretic Flow: 1000rpm (160L), 1500rpm (240L)
Number of Impellers: Single stage
Pump Shaft Position: Horizontal
Nominal Displacement: 160 cc/rev
Nominal pressure: 31.5 Mpa
Material: Cast iron
Weight: 160 kg
Warranty: 12 Months
125 hp Single Acting Axial Piston Pump Dimension (unit: mm)
B
b
bo (N9)
b1
b2
b3
D0
D1 (f9)
D2
D3
d (h6)
d1
d3
329
340
16
100
120
90
198
150
240
300
55
52
M22 x 1.5
h1
h3
L
I
I0
I1
I2
I3
I4
I5
t
d0 x h0
141
25
525
106
100
4
110
180
230
411
59
M16 x 35
Axial Piston Pump Detail
Tips: What should be noted when using the oil pump?
The inlet and outlet of the oil pump must be fitted with a combination of gaskets and a layer of grease on the outside of the pipe joint after it is connected to prevent air from entering.
Be sure to fill the oil return hole before use, otherwise the oil pump will be short of oil and instant wear.
After injecting oil and connecting all the pipes, it should be idle for 10 minutes and then start to play pressure, so that the residual air in the pump and pipes can be discharged.
The oil pump’s oil inlet can not be installed with a screen or filter, which will cause damage to the oil pump due to insufficient oil suction. The filter can be installed in the oil tank or in the oil outlet.
